Veganfloyd's latest activity

Well spotted, I was just about to point that out. However, why did previous owner solder that wire?? Hmm Did he have any issues? was he...

Also measure resistance with each probe to each of the golden bits as you have it disconnected.

From your latest pics, it looks like both wires are unplugged from the speaker. You have 2 terminals, put one probe on one terminal and...

That is a good reading for a 4 ohm speaker. There is still a question about how good a connection we have because of the strands pulled...

Possibly all is well except for the voice coil wire going to the terminal hole for the black wire. Do you have soldering skills?

It may be as simple as cleaning up the soldered end, twisting it tightly, and re-soldering. An alligator clip on the voice coil wire...

In #11 @Veganfloyd reports settled dc of just a few mV although settling process is longer than I might have guessed. So likely that...

I very much doubt that soldering was done at factory. If the diaphragms can freely move in and out, without scraping noises, and the...

You could gently "tug" a bit on the questionable voice coil wire that appears to be somewhat disconnected and see if it is firmly...

Thank you, all. Things are getting weirder and weirder. I thought it might be a good idea to swap the woofers to see if the one...

None at all. My local audio dealer works with a reasonably priced repair centre, so I will pass this on to them. They already started...

Thank you guys. I am getting again 0.1 ohm readings after falling down from initial larger values when touching a speaker binding post...

Thank you, it's 3.1 ohms.

Thank you, Bob. I understand that the task was to measure at the golden bit revealed by unplugging the wire. The reads were 0.1 ohm...

Here's how the points I have marked should look like: Yours are completely burned. That's not an easy thing to do. Edit:Also what's...