Hi guys, i have a ZK-1002T and i think it's a bit harsh on the upper range. I can hear noise if i put my ear near the tweeters of my 2.0 two-way stereo speakers. Also, i have ear fatigue from prolongued listening.
I read about putting a Bootstrap snubber in diyaudio, but i am not sure where should i solder the components (10ohm resistor and 330pf cap).
I'm a bit electrical and repair stuff from time to time, but this Class D amplifiers are new to me.
Main Volume pot is 10k.
Bass and Treble pots are 50k each.
If i put the treble pot to the right (increasing), the noise is much more apparent.
If there's another mod that would make this little amp more pleasant to hear, i'm open to your ideas.
Thanks in advance.
I read about putting a Bootstrap snubber in diyaudio, but i am not sure where should i solder the components (10ohm resistor and 330pf cap).
I'm a bit electrical and repair stuff from time to time, but this Class D amplifiers are new to me.
Main Volume pot is 10k.
Bass and Treble pots are 50k each.
If i put the treble pot to the right (increasing), the noise is much more apparent.
If there's another mod that would make this little amp more pleasant to hear, i'm open to your ideas.
Thanks in advance.