Search results

He said he found one… :)

If there is a slight honkyness/boxyness, and I'd like to EQ the 300Hz-800Hz area a little bit. For this 300Hz-800Hz area, what REW smoothing do you recommend to use, before activating the REW Auto-EQ function to calculate the PEQs ? Thank you very much in advance for your valuable inputs.

Interesting new series… Sounded a little better with room furnishings. Looking forward to hear the changes when room treatments are installed…

Interesting video. What do you think?

Hi ASR friends, I need some advise. I have the following subwoofer - Orisun DD+12 - which is a dual driver push-pull subwoofer. https://www.orisun-acoustics.com/os-dd12/ The subwoofer is currently at the room corner with drivers aligned front-back, and I plan to move it to the middle of the...

I just got my Topping DM7 8-ch DAC which resolves my previous clock drift issue while using 2 distinct async DACs. I am reviewing the subwoofer integration REW charts, and I need some advise here. The crossover point is set to 80Hz. The charts below show 3 sweeps from 10Hz to 2kHz with...

Hey folks, I wanted to experiment with PEQ settings. Could anyone ahare what sort of EQ filter parameters these translate to (roughly) * warm sounding * musical Ex: is warm sounding = high shelf cut starting 5kHz + PEQ boost @ 500hz Q=1.0 ?

As requested by some members, starting a new thread on this recently released software called VB Matrix. https://vb-audio.com/Matrix/ Setup guide: https://forum.vb-audio.com/viewtopic.php?t=1807&sid=7b41ab762ce5b5bdcf525e097526e77b

Recently I went down the path of integrating my subwoofer with the stereo mains using 2 USB DACs. I did not realize beforehand that running 2 USB (async) DACs is not a good idea, and risk them getting a little out of sync with each other. I know the proper solution is to use a multi-channel DAC...

Gosh… https://www.monoandstereo.com/?p=24892

Would the concept of "system" SINAD (from source to speakers) be useful in component selection for a good stereo system? Let's assume a listening SPL of 85dB @ 1m, and a room noise floor of around 40dB SPL. Assuming +20dB headroom for signal peaks, and another -20dB noise headroom. A system...