Just a quck update on the forthcoming P701 monoblock power amp.
I was going to be releasing a NC500 based mono block amp next month, however the NC1200 module has just been released and I will be utlising this module instead. The NC1200 has basically the same or better performance than the NC500. Major difference is that its drive capabilities have been greatly improved. The NC1200 8 ohm rating is 400 watts, 4 ohm is 700 watts and 2 ohms is 1200 watts. Current output is now 38 amps. The NC500 would manage 400 Watts, 700 Watts and 550 Watts and 26 amps respectively. As such this will drive the most difficult of speaker loads. Noise and distortion levels really are superb. In the typically used range, around 5 watts THD is about 0.0007% or -103 dB.
Note the buffered 128dB SNR and 20uV noise levels
Some Hypex data
I was going to be releasing a NC500 based mono block amp next month, however the NC1200 module has just been released and I will be utlising this module instead. The NC1200 has basically the same or better performance than the NC500. Major difference is that its drive capabilities have been greatly improved. The NC1200 8 ohm rating is 400 watts, 4 ohm is 700 watts and 2 ohms is 1200 watts. Current output is now 38 amps. The NC500 would manage 400 Watts, 700 Watts and 550 Watts and 26 amps respectively. As such this will drive the most difficult of speaker loads. Noise and distortion levels really are superb. In the typically used range, around 5 watts THD is about 0.0007% or -103 dB.
Note the buffered 128dB SNR and 20uV noise levels
Some Hypex data
Last edited: