@MicroAudio that make sense. Thank you for explanation.
@phoenixdogfan at the end - for sure it is not something to worry about. I performed small investigation if this is something unusual and if it can be mitigated.
I faced another problem with READY signal. I planned to use it to feed burton’s LED when amp is fully operating.
It should be high when amp is ready (two red leds on Eval1 board are on). Unfortunately my multimeter shows strange thing but usually voltage close to 0.
Based on documentation R6_A1/A2 resistors should not be present for HW mode.
My board looks like follows.
There is a smd element without description but with white line.
My board seems to be somehow 50/50 in HW/SW mode
Do you have similar smd in place of R6_A1/A2?
@phoenixdogfan at the end - for sure it is not something to worry about. I performed small investigation if this is something unusual and if it can be mitigated.
I faced another problem with READY signal. I planned to use it to feed burton’s LED when amp is fully operating.
It should be high when amp is ready (two red leds on Eval1 board are on). Unfortunately my multimeter shows strange thing but usually voltage close to 0.
Based on documentation R6_A1/A2 resistors should not be present for HW mode.
My board looks like follows.
There is a smd element without description but with white line.
My board seems to be somehow 50/50 in HW/SW mode
Do you have similar smd in place of R6_A1/A2?