MRC01
Major Contributor
I've used REW for a while now, taking measurements, importing sweeps, no problems. I just ran into one that I can't figure out.
Using version 5.20 Beta 4, I generated frequency sweep files. Played them back while recording.
Then I go back to REW (same 5.20 Beta 4) and import the sweep recording. REW gives me this error:
Problem is, the error message is incorrect. This sweep file was indeed generated from the very same version of REW into which I'm importing it! And the purple chart shows that REW did indeed read the sweep file.
So, REW must be looking for something in this audio file that it's not finding. What could that be? You can see the sync pulse is also there just before the sweep.
I've done this lots of times and never seen this before.
Using version 5.20 Beta 4, I generated frequency sweep files. Played them back while recording.
Then I go back to REW (same 5.20 Beta 4) and import the sweep recording. REW gives me this error:
Problem is, the error message is incorrect. This sweep file was indeed generated from the very same version of REW into which I'm importing it! And the purple chart shows that REW did indeed read the sweep file.
So, REW must be looking for something in this audio file that it's not finding. What could that be? You can see the sync pulse is also there just before the sweep.
I've done this lots of times and never seen this before.