audio2design
Major Contributor
- Joined
- Nov 29, 2020
- Messages
- 1,769
- Likes
- 1,842
KSTR,
I don't see that as a typical crossover response at all, not at the finished speaker. Do you have phase measurements of a completed speaker. A designer is not going to "miss" so called phase inversions as it would cause quick drop off all but where the frequency alignment is, but that does not happen as the electroacoustic output of the driver and crossover is well down in magnitude.
I don't see that as a typical crossover response at all, not at the finished speaker. Do you have phase measurements of a completed speaker. A designer is not going to "miss" so called phase inversions as it would cause quick drop off all but where the frequency alignment is, but that does not happen as the electroacoustic output of the driver and crossover is well down in magnitude.