Hey everyone,
I have a Bel Canto DAC2 (as in 2.0) which has partnered my CDP for many years and is still going strong in that line of duty. It is also connected to and works with my Chromecast Audio.
I recently acquired a new streamer, a Yamaha WXC-50. The WXC-50 has been used with its analogue outputs successfully, in both Player and in PreAmp mode.
Today, just for funs, I reconnected the Coax cable into the Bel Canto DAC2 to the digital out of the WXC-50, in its Player setting.
A total failure. The Bel Canto DAC couldn't get a S/PDIF connection - the DAC's Status LED flashed between red and green continuously ( producing no audible output).
Did I do something wrong?
The music was streamed from Quboz which said it was a 96kHz source. The Bel Canto is meant to accept 24/96 input.
Any ideas, or write off the idea of using the BC with the WXC-50?
I do not have another DAC which I could try.
Thanks
Tony
I have a Bel Canto DAC2 (as in 2.0) which has partnered my CDP for many years and is still going strong in that line of duty. It is also connected to and works with my Chromecast Audio.
I recently acquired a new streamer, a Yamaha WXC-50. The WXC-50 has been used with its analogue outputs successfully, in both Player and in PreAmp mode.
Today, just for funs, I reconnected the Coax cable into the Bel Canto DAC2 to the digital out of the WXC-50, in its Player setting.
A total failure. The Bel Canto DAC couldn't get a S/PDIF connection - the DAC's Status LED flashed between red and green continuously ( producing no audible output).
Did I do something wrong?
The music was streamed from Quboz which said it was a 96kHz source. The Bel Canto is meant to accept 24/96 input.
Any ideas, or write off the idea of using the BC with the WXC-50?
I do not have another DAC which I could try.
Thanks
Tony