I have an old Assemblage 300B single-ended speaker amp I’m not using at the moment. Is there any way to use or adapt this amp to drive my Sennheiser 6xx headphones? It outputs at best 8 Watts per channel, and is currently wired for 8 ohm speakers.
I did some research and found the with a resistor or two it’s possible to adapt a solid state amp to drive cans. But, I saw vague warnings not to attempt this with tube amps - something about it’s not good for the output transformers.
This is all in the spirit of fun — don’t want to risk damage to the amp or the headphone.
I did some research and found the with a resistor or two it’s possible to adapt a solid state amp to drive cans. But, I saw vague warnings not to attempt this with tube amps - something about it’s not good for the output transformers.
This is all in the spirit of fun — don’t want to risk damage to the amp or the headphone.