View attachment 170135View attachment 170136
It's a tight fit but it fits the nichicon 63v 1000uf
Safety certification says EU FU
is there any options for adding a subwoofer at aiyima a07?
thx. So, the only problem will be the volume? I will use it thru bluetooth, so i will control the volume from my phone or laptop. The output quality of 3.5mm jack will be ok you think?Active or passive? It passes the input signal through its 3.5mm jack - that can be wired to an active sub. But it bypasses the volume knob, so impractical if you plan using A07’s volume control. For a passive sub, you would need a second amp…
The output quality of 3.5mm jack will be ok you think?
RMS
much thanks.
Which tpa3255 board did you buy? They don't all have the same performance.much thanks.
I bought the tpa3255 board at around $25
I will test it with my Klipsch R-41M (50w rms / 100w peak)
I'm thinking about putting 36V 5A configuration
Which tpa3255 board did you buy? They don't all have the same performance.
"hiss on sensitive tweeter" only on turn on/off circuit?ShuiYuan does not have pop issues on power on/off. But there is hiss on sensitive tweeter.
Yes - we need higher rail-voltage and good driver stages for real world loadsPower supply voltage is way more impotent than continuous power!
for any kind of real world load or for any kind of real world signal (aka music)
and especially for a the combination of real world load and real world music
Yes, it is easy to add one as long as you are using an active sub. I have an A08 (same unit virtually) and you just need to use the speaker level inputs on the sub and wire them to outputs on the A07 (along with your speaker wires). You can use spades for the sub and bananas for the speakers, or find splitter wire. Set the relative volume appropriately on your sub and the A07 will control the overall volume of your speakers and sub in tandem.is there any options for adding a subwoofer at aiyima a07?
thanks. Could you post a link of your subwoofer?Yes, it is easy to add one as long as you are using an active sub. I have an A08 (same unit virtually) and you just need to use the speaker level inputs on the sub and wire them to outputs on the A07 (along with your speaker wires). You can use spades for the sub and bananas for the speakers, or find splitter wire. Set the relative volume appropriately on your sub and the A07 will control the overall volume of your speakers and sub in tandem.